EPS geofoam is available in a range of compressive resistances. A project designer can choose the specific type of EPS required to support the design
loading while minimizing cost. Several different types of EPS geofoam can be specified on a single project to maximize savings. For example, higher
strength EPS geofoam can be used in high applied stress areas while lower strength blocks are used in areas where the applied stresses are lower.
EPS geofoam design loads are recommended to not exceed the compressive resistance at 1% capacity. This limit controls the amount of long-term deflection, or creep, resulting from permanent sustained loads.
Note: Adequate soil cover, or a load distribution slab, may be needed to distribute heavy concentrated loads.